Our machines run on 208-220 volt 3 phase service to
run motors.
We also require 120 volt service for control and 80 psi clean and dry compressed
air.
All our machines operate under electrical control with pneumatic clamping.
Kerf cut your riser boards for ¼ round bullnose and ½ round bullnose steps with
the Kerf-It™ automatic kerf cutter.
Adjust the depth of kerf cut or spacing between kerf cuts with just the turn of
a knob.
Of course repeating the same kerf cuts over and over again requires no
adjustment.
Get consistent kerf cuts enabling you to easily bend solid wood boards to any
radius bullnose.
This bullnose saw is a fully automatic kerfing saw.
