Our machines run on 208-220 volt 3 phase service to
run motors.
We also require 120 volt service for control and 80 psi clean and dry compressed
air.
All our machines operate under electrical control with pneumatic clamping.
Cut your tread boards in preparation for applying your tread returns.
Adjust the length of scrap, depth of nosing and angle for return.
Once things are set repeating the same tread return cuts over and over again requires no
adjustment.
Get consistent cuts enabling you to easily fabricate the treads you need when
you need them.
This tread saw is a fully automatic tread return up-cut saw.
